Philco Components:

  (L6, L7, L8, L22) RF-IF COIL (Adjustable) "Blank" - Wind your own coil on this BLANK and measure your Inductance. Has four prongs. (See G4242L Schematics: Could be used to re-wire 1st-4th Video IF Adjustable Coils, No's  L6, L7 and L8 on the schematics. You might have to "bend" the prongs to fit the circuit board holes. ALSO may be used to re-wire wind your L22 "PRI 140 Ohm" Transformer Horiz. Osc. Coil, which has three prongs! (Good Luck re-winding this one!) ..............................  COIL001 .......$3.50 ea.

L6,7,8 Measure at....  .09  -  .015 Range.

L22  140 ohm.

(Same as above - different style) Adjustable BLANK. ....COIL002.....$2.00 ea.

(L12, L15, L17)   RF-IF COIL " BLANK": Re-Wind your own RF-IF coil with this fine "blank". Two pronged. Fits the Holiday and other Predicta TV's...................  COIL003 ........./.. $3.50ea.

See G4242L Schematic Coils Numbers:

(L12)  4.5MC Trap Coil (RF-IF). Philco Part # 32-4644-15.

(L15)  1st Sound IF Coil. Philco Part # 32-4644-12 and 32-4745-2.

(L17)  Quadrature Coil. Philco Part # 32-4644-13.

Another smaller coil BLANK.  Four pronged. Adjustable. COIL004... $2.00 each

You know what this is. ......PRONG-001...............  $0.50 each / 5 for $2.00.

Another Version. ...............PRONG-002.....................$0.50 each / 5 for $2.00.

IRON FERRITE ADJUSTABLE RF-IF COIL SCREWS: RE: Above RF-IF Coils: Are your Coil's adjustable screws cracking and crumbling? Get these NEW ferrite adjustable screw cores! These adjustable screw "cores" fit all the above COIL001,2,3 coil "Blanks". Can be chopped and cut down to fit shorter coils try replacing your screws BEFORE you try re-winding a blank. Be careful and don't ruin your Coil or you WILL have to re-wind a new one! .............................................................SCREWS-001.... $1.00 each / 10 for $8.00

The Old One C7, C8, C9, C11 The New Adjustable Capacitor(s) to replace those worn out Video IF Board Adjustable Cap's. G4242L . Must re-work the prongs for the Vid. IF Board holes. (If you know of a better part and supplier, send the Name and part number for us!?......................................................CAP-001... $4.00 each.

(C8)  .5-3 Cap'r.  (C9) 1-5 Cap'r

(C7) .5-3 Cap'r.  (C11) 1-5 Cap'r.

(R6) THAT LITTLE "BUZZ" POT!   The Schematics say 600 ohm. This is a 500 Ohm, the closest I can find. I just don't think they make 600 ohm one's anymore? You might try this and see if you get good results? I find it OK on my Predicta. .........................BUZZ-001.... $3.00 each.

Potentiometers: 350K, 70K.  Fits Predicta Tv's. $3.00ea.

PREDICTA COMPONENTS LISTED ON SCHEMATICS:

R2A = Brightness, 250K 

R3A = Vertical Hold, 30K  

R4A = Horizontal Hold, 30K

Potentiometers: These are 3meg, and 1.5meg.....$3.00ea.

PREDICTA COMPONENTS LISTED ON SCHEMATICS:

R2B = Vertical Linearity, 1000 ohm

R3B = Height, 3.4meg, or 2.5meg

R4B= Horizontal range, 250K

R5A = Width, 12K

OTHER CONTROL POTS:

R1A = Contrast, 1meg, or 2meg

R1B = Volume, 2.5meg, or 2meg

R1C = Switch - push-push Switch

R5B = Shaft

(R6) Potentiometer POTS, 500 ohm: Can be used to replace the BUZZ Pots...................................................................................$2.00ea.

(L16) 2ed Sound IF Adjustable Coil: 119  8-31  4.4MC Philco Part # 32-4745-2. Predicta Holiday Model G4242L. ( Can anyone supply a Electronics Supply house that has new ones? Please send comments and technical support and a supplier for this item.)..................?.............$? 

AC FILTER CHOKE: ( G4242L Component Part # L23  .270A, 41 ohm, 1.3Hy. Philco Part # 32-8710-4. Thordarson #26C44.)  Filter Chokes: Can use any 300W 3amp 50-400Hz, up to 230V EMI Filter. ..........................................................................................$20.00ea. (Until cheaper supplier is found.)

AC CORD FOR PHILCO PREDICTAS: ...............$3.00 ea. Plus Postage.

POST: USA Add: $2.00 CANADA Add: $4.00 OTHERS ADD: $6.00 Postage for LARGE orders will be notified.

CONTACT rossmarshall@bigvalley.net